Memorial Day Sale
Get 20% OFF on All Products Use code: MEMORIAL20
Sale Ends In :

Contact Us
206-981-5371
0 CART
x

Pet-Immune Motion Detector

This article contains instructions for programming a Pet-Immune Motion Detector with the S03 system.

NOTE: If you purchased the motion detector as part of a kit, then it has been pre-programmed to the main panel already, and no other programming is needed. Follow these steps below if you have purchased a motion detector separately, and are now adding it to an existing system.

Pet-Immune Motion DetectorPet-Immune Motion Detector

Programming the Pet-Immune Motion Detector to the S03 Main Panel:

  1. Turn any other motion detectors OFF. Turn the motion detector that you are programming ON.
  2. On the Main Panel, enter the following:
  3. <your 4-digit password> #
  4. 7 # <2-digit zone number> #
  5. Press and release the 'Code' button. The LED light will flash quickly.
  6. Press and release the 'Code' button again. The main panel will beep twice.
  7. On the Main Panel, press #.
  8. Turn any other motion detectors back ON.


It's also a good idea to make sure that the Zone's attributes for the motion detector are set to Zone Type 5 ('Home'). To set a Zone to Zone Type 5, do the following:

On the Main Panel, enter the following:
<your 4-digit password> #
* <2-digit zone number>
2 5 #
#

Please note you can also change individual sensor attributes via the My Fortress mobile app on your smart phone by going to Management->Sensors->Sensors

 
Get
10% Off
On Any Order Value by Subscribing
NO Thanks