St. Patrick's Day Sale
Get 25% OFF on All Products Use code : GREEN25
Extended
Sale Ends In :

Contact Us
206-981-5371
0 CART
x

Safeguard - Adding Accessories

This article contains instructions for programming additional accessories with the Safeguard Stand-Alone Alarm.

NOTE: If you purchased the accessories as part of a kit, then they have been pre-programmed to the Safeguard already, and no other programming is needed. Follow these steps below if you have purchased an accessory separately, and are now adding it to an existing system.

Safeguard

Programming an Accessory with the Safeguard:

  1. Turn off any motion detectors to prevent accidentally programming them.
  2. Press and hold the Arm/Disarm button for 5 seconds. The Safeguard will beep and all the lights will turn on.
  3. If you are adding a remote control, press any button on the remote now. Otherwise, press the Arm/Disarm button again to select one of the four available zones, then continue to the next step.
  4. Trigger the accessory. The Safeguard will beep again.
  5. Press the Arm/Disarm button again (possibly multiple times) until all the lights are off.
  6. Turn on any motion detectors that were turned off.

Compatible Accessories:

Door / Window Contact - trigger by separating the magnet from the sensor

Door / Window Contact

Motion Detector - trigger by waving in front of it

Motion Detector

Pet Immune Motion Detector - trigger by waving in front of it

Pet Immune Motion Detector

 

Remote Key Fob - trigger by pressing any button on the fob

Remote Key Fob

 

Smoke Alarm - trigger by pressing the Test button

Smoke Alarm

Panic Button - trigger by pressing the Panic button

Panic Button

 

Vibration Sensor - trigger by tapping on the vibration sensor

Vibration Sensor

Glass Break Sensor - trigger by tapping on it

Glass Break Sensor

 

 
Get
10% Off
On Any Order Value by Subscribing
NO Thanks