Contact Us
206-981-5371
0 CART
x

Guardian - Adding Or Removing Emergency Accessories

This article contains instructions for programming additional accessories with the Guardian Stand-Alone Alarm.

NOTE: If you purchased the accessories as part of a kit, then they have been pre-programmed to the Safeguard already, and no other programming is needed. Follow these steps below if you have purchased an accessory separately, and are now adding it to an existing system.

The Guardian can be programmed with "Normal Accessories" and with "Emergency Accessories." This article contains the steps for adding "Emergency Accessories" to the Guardian. There is a separate article with instructions for adding "Normal Accessories."

Normal Accessories

Programming an Emergency Accessory with the Guardian:

  1. Turn off any motion detectors to prevent accidentally programming them.
  2. Press and hold the "music note" button for 3 seconds. The Guardian will beep, and the light will turn on.
  3. Trigger the accessory. The Guardian will beep again.
  4. Turn on any motion detectors that were turned off.

Deleting / Removing All Emergency Accessories:

  1. Press and hold the "music note" button for 3 seconds. The Guardian will beep, and the light will turn on.
  2. Press and hold the "music note" button agan for 5 seconds. The Guardian will beep and flash 5 times.

 

Compatible Emergency Accessories:

Panic Button - trigger by pressing the Panic button

Panic Button

 

Smoke Alarm - trigger by pressing the Test button

Smoke Alarm

 
Get
10% Off
On Any Order Value by Subscribing
NO Thanks